*Photos by Isis3d.net – The Gyroid XL was 3D printed on the new Dual Extruders ISIS3D 3d printer with water soluble PVA for support.
*New photos sent to me by a U.K Maker David Trewren:
“Many thanks for your advice and support !
I was already printing when you replied so thought I would let it run – success at last ! I actually ended up adding manual
support structures using MeshMixer.
The automated support was either not enough or way too much.
I elevated the Gyroid from the bed by 5mm and manually added stilts plus a 10mm brim. Then on waves of the Gyroid that were negative as in wave peak lower than crossing points I added a small amount of support. I found positive peaks and interior structure didn’t require support.
To further improve the surface I finished with a textured bronze spray.”
*Pink Gyroid by maker: Donald Flynn